Tile Cross Spacers in Four Joint Widths, 100 Pcs Per Bag

Buyers rarely get to choose a tile joint width freely. The grout line is set by the tile format, the tile's dimensional tolerance, and the look the client has already signed off. The fixing then has to follow that decision. Our cross spacer range now covers four joint widths, so one clip family can serve a full distributor catalogue instead of three.

What the Range Covers

The range runs at 1.0 mm, 2.0 mm, and a custom group at 1.5 mm, 2.5 mm and 3.0 mm. All four share the same body and the same central pull-out handle, which is the feature that lets an installer release the spacer after the adhesive has set. Standard packing is 100 pieces per bag, and the bag printing can carry your brand rather than ours.

• 1.0 mm. Thin-joint interiors, rectified porcelain, and commercial floors where the design calls for a fine line.
• 2.0 mm. The volume specification. Standard ceramic and porcelain floors on mid-range commercial and residential projects.
• 1.5 / 2.5 / 3.0 mm. Wide-joint work, natural stone, rustic ceramic and exterior paving, quoted as a custom group.

The handle sits 8 mm high and 7.3 mm wide at the centre of the clip, which is enough to grip and pull without a tool.

Joint Width Follows the Tile

Rectified porcelain is cut after firing, so its edges sit within a tight tolerance and a narrow line stays visually even. Non-rectified tile is not: its edge variation can exceed the joint itself, and a 1 mm line will read as inconsistent across a floor even when every spacer is correct. Natural stone behaves differently again, because it moves with moisture and needs a joint wide enough to absorb that movement. The useful question at quotation time is therefore which tile is actually going down, not what the drawing shows.

A cross spacer does one job. It holds the gap between two tiles at a fixed width while the adhesive cures, then it comes out. It does not lift a tile into plane, and it does not correct a substrate that is already out of level. Uneven substrates, trowel ridges and variation in tile thickness are separate problems, solved in the screed, the adhesive bed and the tile selection. Where a supplier offers a single product that claims to do both, test it on one room before committing a container to it.

The Four Widths in Practice

Packaging and Private Label

Every width ships at 100 pieces per bag, which suits both trade distribution and single-project supply. Bag printing, carton artwork and mixed-width loads can be arranged for distributors launching their own range, and the packaging is produced to your artwork rather than to ours.

FAQ

Which width should a distributor stock first?
The 2.0 mm. Standard ceramic and porcelain floors are where the volume sits, and the neighbouring widths are easier to add once that line is moving.

Do these spacers correct uneven tiles?
No. They set joint width only. An uneven tile face comes from the substrate, the adhesive bed or variation in tile thickness.

Can the bags carry our own brand?
Yes. Bag and carton artwork are produced to your specification.

Yifang Plastic moulds tile cross spacers in 1.0 mm, 2.0 mm and custom joint widths at its facility in Langfang, Hebei. The full range, including packing options, sits under tile cross spacers and spacers, with the 1.0 mm clip and the custom 1.5 / 2.5 / 3.0 mm clip listed separately. The edge tolerance that decides how even a narrow joint reads is defined in the tile standard your market applies, such as ISO 13006. The clip products that sit alongside these spacers are a different family, and the reasoning behind that range is set out in an earlier note on clip design.