logo
Langfang Yifang Plastic Co.,Ltd
Email sales@lfrfeng.net TEL: 86-0316-2605138
Home
Home
>
News
>
Company news about Cap Nails and Stick Pins for Roofing Underlayment
News & Insights
LEAVE A MESSAGE

Cap Nails and Stick Pins for Roofing Underlayment

2026-11-19

Latest company news about Cap Nails and Stick Pins for Roofing Underlayment

An underlayment or facing membrane arrives with a fixing schedule that assumes a particular head, shank and coating. Leave one of those three off the order and the membrane still looks fixed on the day it is installed. It lifts at the first serious storm instead, and the callback costs many times the fastening.

What a Cap Nail Has to Do

A cap nail resists two forces that pull in opposite directions. Pull-out is the shank losing its grip in the deck, which is why ring shank and screw shank nails hold better than plain shank in low-density substrates. Pull-through is the head punching through the membrane, and here the cap does the work.

  • Cap. A round cap spreads the load across a wider area of membrane than a bare nail head. That spread is the difference between a membrane that stays put and one that tears at every fixing.
  • Shank. Ring shank and screw shank resist withdrawal, while plain shank drives faster and over-drives more easily.
  • Coating. Decides how long the nail survives inside the deck, and it is the item most often missing from a quotation.

Matching the Fixing to the Surface

Our four fixing types are not interchangeable, and each one is made for a particular surface and a particular direction of load.

FixingWhere it belongsWhat to ask the supplier
Ring shank cap nailUnderlayment and felt on a timber deckCap diameter against the membrane weight
Screw shank cap nailFixings that may be withdrawn and resetWhether over-driving strips the thread
Plain shank cap nailFast sheathing work on a dense deckWithdrawal resistance in the actual deck
Stick pin with capInsulation facing, duct wrap, vapour barrierPin length against the facing thickness

Coating Decides Service Life

Steel in a roof sits in the same atmosphere as the building, and the coating costs little next to a re-roof. Atmospheric corrosivity is classified in EN ISO 9223, which rates environments from C1 for heated interiors up to C5 for coastal and industrial exposure. A galvanised nail that is sensible on an inland warehouse is the wrong choice a few hundred metres from salt water. The reverse also holds: stainless steel on a dry inland shed buys nothing the galvanised nail was not already delivering.

Ask for the coating class rather than the finished colour. Where a quotation names a nail length and says nothing about coating, it is not a specification yet.

Wind uplift is a calculation for the roof designer, and it depends on the membrane, the deck, the pitch, the edge zones and the local wind speed. We can document the fixing we supply. We cannot certify the roof, and a supplier who offers to do so without the designer's figures is guessing on your liability.

Where Stick Pins Fit

Stick pins hold insulation facings, duct wrap and vapour barriers where the membrane is pierced once and then capped. The cap locks onto the pin, so the facing is held without a wide head pulling through the material. The corrosion logic is identical to cap nails, and the cap is again the part doing the work. Pin length is set by the thickness of the facing rather than by the deck, and that figure is the one most often left off an order. Ask for it in millimetres, and check it against the thickest board in the build-up.

FAQ

Ring shank or screw shank?
Ring shank for most underlayment work. Screw shank where the fixing may need to be withdrawn and reset without losing grip.

Does a larger cap always help?
Up to a point. A wider cap spreads load further, and it still needs to seat flat, so an oversized cap on an uneven deck can stand proud of the surface.

Can lengths and coatings be mixed in one order?
Yes. Lengths and coating classes can be combined within a single carton and container plan.


Yifang Plastic moulds cap nails and supplies companion stick pins from Langfang, Hebei. The fixings are listed under plastic cap nails, including the 24.5 mm round capped roofing nail and the house wrap screw shank nail. Stick pins sit in the metal fasteners and stick pins range. For the site-level view of how these fixings are used, see what plastic cap nails are used for.

Contact Us at Any Time

86-0316-2605138
Huangdewu Industry Zone, Dacheng County, Langfang City, Hebei Province, China
Send your inquiry directly to us